System M - Factory Swaged DIY Balustrade Wires for Masonry Fixing

System M - Factory Swaged DIY Balustrade Wires for Masonry Fixing

The Masonry Anchor with Swaged Stud Slimline Balustrade System is an elegant looking stainless steel balustrade, with the tensioning mechanism inside the metal anchor posts.

Enter the total number of System M wires required and add to cart.  By using Quickshop, you can add the things you need without leaving this page.

Calculate the total length in whole metres of wire rope required (number of wires per run x total length of all runs).

If you have stairs runs, add 1 x SWCP LHT and 1 x SWCP RHT for each wire in each stair run.

Add any other accessories you need (eg Masonry Anchor Drift).

You'll need to send us a separate email with your required run lengths, for example:

3250 x 11, 4146 x 11, 2545 x 10 + SWCP - which means:

11 wires @ 3250mm, 11 wires @ 4146mm, and 10 wires for stairs @ 2545mm including swivel connectors.

Note all measurements should be inside post to inside post, with stairs measured the same way but parallel to the handrail.

Installation Instructions

You recently viewed

Clear recently viewed